Epson EMP 71, User Manual

Page: 30 / 86

Using the Projector
25
What To Do If You See a Blank Screen
If you see a blank screen or a blue screen with the message
No Signal
after turning on your computer or video source, do one of the
following:
■
Make sure the cables are connected correctly, as described in
Chapter 1.
■
Make sure the
Power
light is green and not flashing and the
lens cap is off.
■
If you’ve connected more than one input source, you may need to
press the
Source
button on top of the projector or the
Computer
,
Video
, or
S-Video
button on the remote control to
select the source you want to use. (Allow a few seconds for the
projector to sync up after pressing the button.)
■ Try restarting your computer.
■ If you still don’t see an image and you’re using a PowerBook, see
page 26 or 27 for additional steps. If you’re using a PC laptop,
see page 28.
Source button
Computer,
Video, and
S-Video
buttons