Epson ELPHC100, User Manual, Page: 80 / 132

80
3
Select one of the following:
•
LEARN
to erase commands that were learned from another remote control
•
MACRO
to erase macros you created
4 At the next screen, select one of the following:
•
ALL
to erase all learned commands or macros. When you select this option, you see SURE? displayed
on the screen. Select
SURE?
to erase the settings, or select
EXIT
to cancel.
•
DEVIC
to erase all commands or macros for a specific device. When you select this option, you see a
list of devices (DVD, CABLE, SAT, etc.). Select the device whose settings you want to erase. You see
ERASED! displayed at the bottom of the screen.
Caution
Be careful to select the correct device. If you select the wrong one, you won’t have the option to cancel.
•
KEY
to erase a single command or macro. When you select this option, you see a list of devices (DVD,
CABLE, SAT, etc.). Select the device that has the command or macro in its menu that you want to
erase, then select the command or macro. You see ERASED! displayed at the bottom of the screen.
Caution
Be careful to select the correct command or macro. If you select the wrong one, you won’t have the option to
cancel.
5
Press the
MAIN
button several times to return to normal operation.
Using Remote Control Punch-Through
The Ensemble HD remote control is pre-programmed to let you operate various devices, each from its own
menu. For example, if you’ve connected a high-definition DVD player, you can operate it from the HD menu;
or you can operate a satellite receiver from the SAT menu. However, you may want to be able to operate your
high-definition DVD player from the MAIN menu so you can also access the Ensemble HD setup menu, and
adjust the picture or sound at the same time, for example. To do this, you create a “punch through.” This lets
you use the remote control to operate certain functions of one device, while you have the menu screen open for
another device. (You can punch commands through any menu, not just the MAIN menu.)
Note
The volume control is automatically punched through to your home theater system from every device.
Follow these steps to set up a punch-through:
1 Enter Setup mode by pressing and holding both the
MAIN
and
ENT
buttons for three seconds. The top of
the screen displays SETUP.
Note
You have 30 seconds to complete each step. After that, the remote control returns to normal operation.
2 Select the
PUNCH
option. (You may have to press
PAGE
or to see it.)