Starting the Program
Follow these steps to start the System diagnostics program:
1.
2.
3.
4.
5.
6.
7.
8.
Insert the Reference 1 diskette in drive A and turn on or reset
the computer.
boot the computer from the Reference 1 diskette
to start System diagnostics. This clears from memory
protected mode terminate-and-stay-resident (TSR)
or other utilities and frees it for use by the
After a moment, you see the title screen for the System
Configuration program. Press any key to continue.
When you see the Welcome screen, press [Enter.
From the Main Menu, select Access to other
utilities. Then select System diagnostics.
When prompted, remove the Reference 1 diskette, insert the
Reference 2 diskette, and then press
You see a menu bar at the top of the screen with Items
Detected highlighted. Press
You see a list of all the testable devices the computer detects
in your system. Check to be sure the list is correct.
If the list is not correct, press I-] to select Quit and press
Run the System Configuration program to make
sure any missing devices are configured properly. Then run
System diagnostics again.
A-2
Running
Diagnostics
Summary of Contents for EISA Series
Page 1: ...H ...
Page 3: ...User s Guide ...
