Adjusting the Image
33
a
Press the [Menu] button to display
menus in the order
Signal
-
Aspect
.
Remote control
Control panel
b
Use the up and down buttons to select
the aspect mode, and then press the
[Enter] button to confirm the
selection.
c
You can only select
Auto
when the source is HDMI1 or HDMI2. This may not be available depending
on the type of input signal.
By normally selecting
Auto
, the optimum aspect is used to display the input signal. Change the setting if you
want to use a different aspect.
The table below shows the image projected on a 16:9 screen.
Aspect Mode
Aspect Ratio for Input Signal
16:10
16:9
4:3
Normal
Full
Zoom
Adjusting the Sharpness
You can make the image clearer.
a
Press the [Menu] button to display
menus in the order
Image
-
Sharpness
.
Remote control
Control panel
The
Sharpness
adjustment screen is
displayed.
b
Use the left and right buttons to make
adjustments.
The image is enhanced when moved to the
right (positive) and softer when moved to
the left (negative).
c
Press the [Menu] button to exit the
menu.
