Adjusting the Image
41
Viewing the Image at the Saved Image Quality
(Memory Function)
Saving a Memory
By using the memory function, you can register settings for
Image
from the Configuration menu, and then
load them when necessary.
a
Make the settings or adjustments you
want to register.
b
Press the [Menu] button to display
menus in the order
Settings
-
Memory
.
Remote control
Control panel
c
Use the up and down buttons to select
Save Memory
, and then press the
[Enter] button to confirm the
selection.
d
Use the up and down buttons to select
the memory name you want to save,
and then press the [Enter] button to
confirm the selection.
The current projector settings are saved to
the memory.
If the mark on the left of the memory name
is turned aqua, it means the memory has
already been registered. When you select a
registered memory, a message is displayed
asking you to confirm that you want to
overwrite the memory. If you select
Yes
, the
previous content is erased and the current
settings are saved.
