Start Here
12
Press and hold the button for
3 seconds until
the power light starts flashing, to begin charging the
ink. Ink charging takes approximately 20 minutes. Ink
charging is complete when the power light stops
flashing.
20 minutes
3 seconds
Note:
The ink bottles included with the printer are designed
for printer setup and not for resale. After some ink is used for
charging, the rest is available for printing.
Caution:
Do not turn off the product or load paper while the
product is charging or you’ll waste ink.
3
Load paper
See the online User’s Guide for information about loading
capacity and available paper types and sizes.
1
Make sure the product is not charging. Then flip the
feeder guard forward, raise the paper support, and tilt it
backwards slightly.
2
Slide the edge guide to the left.
3
Load paper, glossy or printable side up and short edge
first, against the right side of the rear paper feed slot.
Read these instructions before using your product.
1
Unpack
Note:
Do not open the ink bottles until you are ready to fill the ink
tanks. The ink bottles are vacuum packed to maintain reliability. Ink
bottle design may vary.
1
Remove all protective materials from the product.
2
Lift up the scanner unit and remove all protective
materials from inside the product.
Caution:
Do not touch the flat white cable or the ink tubes and
their translucent cover.
3
Lower the scanner unit.
2
Fill ink tanks
Note:
This product requires careful handling of ink. If ink spills, wipe
it off immediately with a damp towel to avoid permanent stains. If ink
gets on your clothes or belongings, it may not come off.
Warning:
Keep the ink bottles out of the reach of children and do not
drink the ink.
1
Open the ink tank cover, then remove the cap for the
black ink tank and attach it to its holder.
2
Unpack the black ink bottle.
3
Depending on the ink bottle included with your product,
snap off the bottle tip or unscrew the lid.
4
Remove the bottle cap. Carefully remove the protective
seal (avoid touching the ink underneath the seal), then
close the bottle cap
tightly.
Caution:
Be sure to close the bottle cap tightly, or ink may leak.
5
Fill the tank using all of the ink in the bottle.
Note:
Refer to the color coded sticker on the ink tank to identify
the color of each tank.
Caution:
Be sure to fill each tank with the correct ink color.
6
Carefully seal the bottle using the reverse side of the
bottle tip or screw on the lid for proper disposal.
7
Replace the ink tank cap securely.
8
Repeat the previous steps for the remaining bottles.
9
Close the ink tank cover.
10
Connect the power cord to the back of the product and to
an electrical outlet.
Caution:
Do not connect to your computer yet.
11
Raise the control panel and turn on the product. Wait for
the power light to stop flashing,
then follow step 12 to
continue ink charging.
Note:
If all the product lights are flashing, turn off the product
and check that no protective material has been left inside
the product.
Caution:
Do not lower the control panel without first squeezing
the release bar underneath or you may damage the product.
L396
