Epson EB-S03, User Manual

Page: 40 / 134

f
Repeat procedures 4 and 5 as needed to adjust any remaining
corners.
g
When you are done, press the [Esc] button to exit the correction
menu.
Because Keystone was changed to Quick Corner , the corner
selection screen shown in step 4 is displayed the next time you press
the [
w
] or [
v
] button on the control panel. Change Keystone to
H/V-Keystone
if you want to perform horizontal and vertical
correction using the [
w
] or [
v
] button on the control panel.
s
Settings - Keystone - H/V-Keystone p.77
a
If the [Esc] button is held down for about two seconds while
the corner selection screen from step 4 is displayed, the
following screen is displayed.
Reset Quick Corner : Resets the result of Quick Corner
corrections.
Switch to H/V-Keystone : Switches the correction method to
H/V-Keystone .
s
"Settings Menu" p.77
Adjusting the Image Size
For EB-X24/EB-W18/EB-X18/EB-W03/EB-X03/EB-W120/EB-X120/EB-
X200
Turn the zoom ring to adjust the size of the projected image.
For EB-S18/EB-S03/EB-S120/EB-S200
Adjust by using the [Wide]/[Tele] buttons on the control panel.
Wide: Enlarges the size of the projected image.
Tele: Reduces the size of the projected image.
Adjusting Projected Images
40