Extended Menu
96
• You are projecting on a matte white diffusion screen that is flat and even.
• The projector is placed so it squarely faces the screen, not at an angle.
• Nothing is blocking the optional external camera and the projected image.
• Projection size is between 80 to 200 inches.
Projector ID
s
Extended
>
Multi-Projection
>
Projector ID
You can set the projector to a particular ID number which allows you to use a
remote control to individually control projectors. This is useful when you
want to control multiple projectors using one remote control.
a
• You need to set the remote control's ID to match the projector's ID
to operate only a particular projector.
To set the remote control's ID, set the remote control [ID] switch to
On
. Press the [ID] button on the remote control and press the
numeric button that matches the projector's ID within 5 seconds.
(Enter a one-digit or two-digit number.)
• If you do not know the projector's ID, press the [ID] button during
projection to temporarily display the projector's ID and the remote
control's ID on the screen.
• You can set up to 30 IDs.
Projector Grouping
s
Extended
>
Multi-Projection
>
Projector Grouping
You can create a group of projectors that you can control simultaneously.
Tiling
s
Extended
>
Multi-Projection
>
Tiling
You can project the same image from up to 9 projectors to create one large
image using the Tiling feature.
Tiling
Set to
Auto
to configure tiling automatically.
If you do not install the optional external camera or tiling the images
automatically was unsuccessful, select
Manual
, and then select the
Layout
and
Location Setup
settings individually.
Layout
Select the number of rows and columns you are setting up.
Location Setup
Select the position of each projected image as follows:
•
Row Order
to layout the screens from top to bottom, starting with 1 at
the top, in sequential order.
•
Column Order
to layout the screens from left to right, starting with A
on the left, in alphabetical order.
Location Info
You can view the name, IP address, and ID of the projector you set.
a
•
Auto
is available only when the optional external camera is installed.
• Make sure nothing is blocking the optional external camera while
performing automatic tiling.
• Do not change any of the projector names or IP addresses, or the
images will not be adjusted automatically.
Edge Blending
s
Extended
>
Multi-Projection
>
Edge Blending
You can blend the border between multiple images to create a seamless
screen.
Edge Blending
Set to
On
to enable the Edge Blending feature.
When not projecting images from multiple projectors, select
Off
.
