f
Select
Tiling
. Select
Auto
, and then press the [Esc] button.
g
Select
Location Setup
, and then press the [
] button.
The image is positioned automatically.
When the message "Assign IDs to projectors that have been located.
Do you want to continue?" is displayed, select
Yes
.
When setup is complete, the following screen is displayed.
a
If the image is not located correctly, select
Manual
in step 6,
and then follow the steps below to locate the image manually.
(1) Set
Row
and
Column
in
Layout
.
(2) Select
Set
, and then press the [
] button.
(3) Select the projector in
Location Setup
, and then press the
[
] button.
(4) Select the position you want to locate, and then press the [
]
button.
(5) Repeat steps (3) and (4) to reposition the location of all
projectors.
(6) Select
Set
, and then press the [
] button.
h
Input the image signal to display the image.
s
"Automatically Detecting Input Signals and Changing the
Projected Image (Source Search)"
When tiling is complete, adjust any positional gaps and the tint of the
projected images.
s
"Adjusting projected images individually"
a
After tiling is complete, do not change the IP addresses or projector
names of the projectors. Otherwise the image will not be adjusted
automatically.
After tiling is complete, you can set each projector with one remote
control. Select the projector ID for the projector you want to set
with the remote control. You can check the projector ID in
Tiling
-
Location Info
.
s
"Setting the remote control ID"
Performing tiling manually
Manually arrange the images being projected for each projector.
Multi-Projection Function
90
Summary of Contents for EB-L30000U
