Epson EB-L30000U, User Manual

Page: 165 / 283

Once the Configuration menu content has been set for one projector, you
can use it to perform batch setup for multiple projectors (batch setup
function). The batch setup function is only for projectors with the same
model number.
Use one of the following methods.

Setup using a USB flash drive.

Setup by connecting the computer and projector with a USB cable.

Set through Epson Projector Management.
This manual explains the USB flash drive and the USB cable methods.
a

The content for Light Source Info and Status Information from the
Info menu is not reflected by the batch setup function.

Perform batch setup before adjusting the projected image.
Adjustment values for the projected image, such as Geometry
Correction are reflected by the batch setup function. If batch setup is
performed after adjusting the projected image, the adjustments you
made may change.

By using the batch setup function, the registered User's Logo is set
for the other projectors. Do not register confidential information and
so on as the User's Logo.

If you do not want to copy the following settings, set Batch Setup
Range to Limited .
- EDID from the Signal menu
- Network menu (except for the Notifications menu and the Others
menu)
s
Extended - Operation - Advanced - Batch Setup Range p.147

Items for which Password Protection is set are not copied.
Caution
Performing batch setup is the customers responsibility. If batch setup fails due
to a power failure, communication error, and so on, the customer is responsible
for any repair costs incurred.
Batch Setup
165