Submenu
Function
Light Source
Control
Light Source Control
: Select the light source operations
according to the image signal.
s
"Setting the Amount of Light of the Projected Image"
Dynamic Contrast
: (This can be set only if
Light Source Control
is set to
Dynamic Contrast
) Automatically adjusts the amount of
light when projecting according to the brightness of the image.
Lights-Out Control
: (This can be set only if
Light Source
Control
is set to
Lights-Out Control
) Automatically turns off
the light after the set time has elapsed at the specified video level.
Reset
You can reset all adjustment values for the
Image
menu to their
default settings except for
Color Mode
. See the following to
return all menu items to their default settings.
s
Signal Menu
Settable items vary depending on the image signal and source currently
being projected.
Submenu
Function
Resolution
*1
(Only available when an analog RGB computer signal is
being input.)
Set to
Auto
to automatically identify the resolution of the
input signal. If images are not projected correctly when set
to
Auto
, for example if some of the image is missing, set to
Wide
for wide screens, or set to
Normal
for 4:3 or 5:4
screens depending on the connected computer.
Manual
allows you to specify the resolution. This is ideal
when connected computer is fixed.
Aspect
*2
You can set the Aspect Ratio for projected images.
s
"Changing the Aspect Ratio of the Projected Image"
Tracking
*2
(Only available when an analog RGB computer signal is
being input.)
You can adjust computer images when vertical stripes
appear in the images.
Sync.
*2
(Only available when an analog RGB computer signal is
being input.)
You can adjust computer images when flickering, fuzziness,
or interference appear in the images.
Position
*2
You can adjust the display position up, down, left, and right
when a part of the image is missing so that the whole image
is projected.
Auto Setup
*1
(Only available when an analog RGB computer signal is
being input.)
Set to
On
to automatically adjust Tracking, Sync., and
Position to the optimum state when the input signal
changes.
Overscan
*2
Changes the output image ratio (the range of the projected
image). You can set the cropping range to
4%
or
8%
. When
set to
Auto
, this is automatically adjusted according to the
input signal.
List of Functions
143
Summary of Contents for EB-L30000U
