Epson EB-L1050U, User Manual

Page: 161 / 291

Info Menu (Display Only)
Lets you check the status of the image signals being projected and the status
of the projector. Items that can be displayed vary depending on the source
currently being projected.
Submenu Function
Projector Info Operation
Hours
*
Displays the operation time after turning on
the projector.
Source You can display the source name for the
connected equipment currently being
projected.
Input Signal
You can display the content of
Input
Signal
set in the
Signal
menu according to
the source.
Resolution
You can display the resolution.
Refresh Rate
You can display the Refresh Rate.
Submenu Function
Sync Info
You can display the image signal
information.
This information may be needed if service
is required.
Status
This is information about errors that have
occurred on the projector.
This information may be needed if service
is required.
Serial Number Displays the projector's serial number.
Lens Type Displays the model number of your lens.
Event ID When problems occur when the projector
and computer are connected through the
network, information on the problem is
displayed using an Event ID. See the
following page for information on
interpreting the Event ID.
s
"About Event ID" p.201
HDBaseT Sig-
nal Level
Displays the level for the image signal being
input from the HDBaseT port. When this is
displayed in yellow, the strength of the
signal level is reduced. We recommend the
following signal levels.
•
1080p: 16dB or more
•
4K: 18dB or more
Light Source
Info Light Source
Hours
Displays the operating time for the light
source according to the light source mode.
Estimated Re-
mains
When Constant Brightness is set to On ,
this displays the amount of time for which
the brightness of the light source can be
maintained.
List of Functions
161