Epson EB-L1050U, User Manual

Page: 155 / 291

Submenu Function
EAP Method
Set protocols for WPA2-EAP and WPA/WPA2-EAP
authentication.
EAP Type : Select the certification protocol.
•
PEAP : Authentication protocol widely used in Windows
Server.
•
PEAP-TLS : Authentication protocol used in Windows
Server. Select when using a client certificate.
•
EAP-TLS : Authentication protocol widely used to use a
client certificate.
•
EAP-FAST , LEAP : Select this when these authentication
protocols are used.
User name : Enter a user name to be used for
authentication. You can enter up to 64 single-byte
alphanumeric characters.
You can enter up to 32 characters on the Configuration
menu. When entering more than 32 characters, use your
Web browser to enter the text.
s
"Changing Settings Using a Web Browser (Epson Web
Control)" p.215
If you also need to enter a domain name, add the domain
name before the user name separated by a backslash
(domain name\user name).
Password : Enter the password used for authentication in
PEAP, EAP-FAST, and LEAP. You can enter up to 64
single-byte alphanumeric characters. You can enter up to 32
characters on the Configuration menu. When entering more
than 32 characters, use your Web browser to enter the
text.
s
"Changing Settings Using a Web Browser (Epson Web
Control)" p.215
When the password is entered and Finish is selected, the
value is set and displayed as an asterisk ( * ).
Client Certificate : Imports client certificates for use in
PEAP-TLS and EAP-TLS.
Submenu Function
Verify Server Cert. : Set to On to perform verification for
the certificate of the certification server. To verify a server
certificate, you need to set CA certificate.
CA certificate : Imports CA certificates for use in PEAP,
PEAP-TLS, EAP-TLS, and EAP-FAST.
RADIUS Serv.Name : Specify the name of the certification
server. You can enter up to 32 single-byte alphanumeric
characters.
Channel You can select the channels used to connect in Quick mode.
If interference from other signals occurs, use a different
channel.
IP Settings * Perform network settings.
DHCP
: Set to
On
to configure the network using DHCP. If
this is set to
On
, you cannot set any more addresses.
IP Address : Enter the IP address assigned to the projector.
You can enter a number from 0 to 255 in each field of the
address. However, the following IP addresses cannot be
used.
0.0.0.0, 127.x.x.x, 224.0.0.0 to 255.255.255.255 (where x is a
number from 0 to 255)
Subnet Mask
: Enter the projector's subnet mask. You can
enter a number from 0 to 255 in each field of the address.
However, the following subnet masks cannot be used.
0.0.0.0, 255.255.255.255
Gateway Address
: Enter the IP address for the gateway for
the projector. You can enter a number from 0 to 255 in
each field of the address. However, the following Gateway
Address cannot be used.
0.0.0.0, 127.x.x.x, 224.0.0.0 to 255.255.255.255 (where x is a
number from 0 to 255)
SSID Display
To prevent the SSID from being displayed on the LAN
Standby screen, set this to
Off .
IP Address Dis-
play
To prevent the IP address from being displayed on the LAN
Standby screen, set this to
Off .
List of Functions
155