Others Menu
Sub Menu
Function
SNMP
Set this parameter to
On
when using SNMP
to monitor the projector.
To use SNMP to monitor the projector, you need to install the SNMP manager program on your computer. SNMP should be managed by a network
administrator.
Trap IP Address 1/Trap IP
Address 2
When
SNMP
is set to
On
, you can set up to two IP addresses as SNMP trap notification destinations.
You can input a number from 0 to 255 in each field of the address.
However, the following IP addresses cannot be used.
127.x.x.x, 224.0.0.0 to 255.255.255.255 (where x is a number from 0 to 255)
Priority Gateway
For the priority gateway, select either
Wired
or
Wireless
.
AMX Device Discovery
When the projector is connected to a network, set this to
On
to allow the projector to be detected by AMX Device Discovery
. Set this to
Off
if you are
not connected to an environment controlled with a controller from AMX or AMX Device Discovery.
RoomView
Set this parameter to
On
only when using Crestron RoomView
®
to monitor and control the projector over a network. Normally, leave this parameter set
to
Off
.
s
Changes in projector settings take effect upon restarting.
The following functions cannot be used when it is set to
On
.
•
Web Control
•
Message Broadcasting (EasyMP Monitor plugin)
Network Menu
73
Summary of Contents for EB-G5450WU
