Others menu
Sub-menu
Function
SNMP
Set to
On
to monitor the projector using SNMP.
To monitor the projector, you need to install the SNMP manager
program on your computer. SNMP should be managed by a
network administrator.
The default value is
Off
.
Trap IP Address
1/Trap IP Ad
dress 2
You can register up to two IP addresses for the SNMP trap
notification destination. You can enter a number from 0 to 255 in
each field of the address. However, the following IP addresses
cannot be used. 127.x.x.x, 224.0.0.0 to 255.255.255.255 (where x
is a number from 0 to 255)
Priority Gateway
You can set the priority gateway to a
Wired LAN
or
Wireless
LAN
.
AMX Device Dis
covery
When the projector is connected to a network, set this to
On
to
allow the projector to be detected by AMX Device Discovery
.
Set this to
Off
if you are not connected to an environment
controlled with a controller from AMX or AMX Device
Discovery.
Sub-menu
Function
Crestron Room
View
Set this to
On
only when monitoring or controlling the projector
over the network using Crestron RoomView
®
. Otherwise, set
this to
Off
.
s
When this is set to
On
, the following functions are not available.
•
Web control
•
Message Broadcasting (EasyMP Monitor Plug-in)
Bonjour
Set this to
On
when connecting to the network using Bonjour.
See Apple's Web site for more information on the Bonjour
service.
Message Broad
casting
You can switch the EPSON Message Broadcasting function to
enable or disable.
You can download Message Broadcasting and its Operation
Guide from the following Web site.
List of Functions
91
Summary of Contents for EB-421i
