Sub-menu
Function
AMX Device Dis-
covery
When the projector is connected to a network, set this to
On
to
allow the projector to be detected by AMX Device
Discovery
.Set this to
Off
if you are not connected to an
environment controlled with a controller from AMX or AMX
Device Discovery.
Crestron Room-
View
Set this to
On
only when monitoring or controlling the projector
over the network using Crestron RoomView
®
. Otherwise, set
this to
Off
.
s
When this is set to
On
, the following functions are not available.
•
Web control
•
Message Broadcasting (EasyMP Monitor Plug-in)
Bonjour
Set this to
On
when connecting to the network using Bonjour.
See Apple's Web site for more information on the Bonjour
service.
Reset menu
Resets all of the network settings.
Sub-menu
Function
Reset network
settings.
To reset all of the Network settings, select
Yes
.
Info Menu (Display Only)
Lets you check the status of the image signals being projected and the status
of the projector. Items that can be displayed vary depending on the source
currently being projected. Depending on the model used, some input
sources are not supported.
List of Functions
74
Summary of Contents for EB-420 guide
