Introduction
7
Part
Name
Application
Markers x2
Attach to the screen to adjust the angle
of the laser emitted by the Touch Unit.
c
When the finger touch op‐
erations do not work cor‐
rectly, you need to use the
markers again to re-cali‐
brate the angle of the laser.
Keep these in a safe place
after installing.
Tape for securing the mark‐
ers
(approx. 6 cm) x12
Secure the markers to the projection
surface.
Infrared deflectors
(approx. 28.5 cm) x8
Use these when there is a tray or frame
at the bottom of the projection surface.
This prevents malfunctions due to laser
reflections.
Spacers for screw holes x3
Attach them to the screw hole when
securing the Touch Unit with screws.
Label x4
Attach the label in the position of the
Touch Unit. These provide markers
when repositioning due to movement
that occurs during use.
Touch Unit Bracket (optional)
Use this when attaching the Touch Unit to outside of the projection surface.
Part
Name
Application
Touch Unit Bracket
-
Template sheet (for Touch
Unit Bracket)
Attach this to the wall before attaching
the Touch Unit Bracket, and use it to
drill necessary holes.
M4 x 25mm hexagon socket
head cap bolts (x2)
Secure the Touch Unit to the Touch
Unit Bracket.
Hexagon wrench (for M4)
-
