Epson EasyMP EMP-735, Setup Manual, Page: 46 / 223

45
E
nglish
ESSID Enter the ESSID used to connect. If the wireless LAN system
used has an ESSID, enter that value. The initial value is
"EPSON."
Up to 16 single-byte alphanumeric characters can be entered.
WEP Key
(HEX)
Enter the key used for WEP encryption. Input a key as
directed by the network administrator of the wireless LAN
system where the projector is added.
Up to 26 single-byte alphanumeric characters can be entered.
Input the key in hexadecimal. The characters allowed are
therefore 0-9 and A-F. For 10 character input use 64(40)-bit
length, and for 26 character input use 128(104)-bit for the
key data. Character counts other than 10 or 26 characters will
not be encrypted. Further, the Key ID value is pre-set to "0".
To enter a value other than hexadecimal or, to set the Key ID
to a value other than "0", access the projector setup broeser
page on the Web browser, and enter the value on that page.
See "Setting, Monitoring and Controlling from a
Computer" in the EasyMP Operation Guide .
Select the "Clear" button, and press the [Enter] button on the
remote control to clear the entered key. Encryption will not
take place.
Password for
WEB control Enter a password. If you enter a password, entry of that
password will be required when; changing the projector
settings via a network from a computer’s Web browser,
opening the settings and control browser page, and when
starting EMP Monitor.
Up to 8 single-byte alphanumeric characters are available.
Select the "Clear" button, and press the [Enter] button on the
remote control to clear the entered password. The password
setting will be inactivated.
Projector keyword
If the projector keyword option is set to "ON", keyword entry
will be required when using EMP NS Connection to connect to
the projector over a wireless LAN. A keyword will be displayed
on the screen of the projector you are trying to connect to.
Please check this keyword and enter it into the computer you are
trying to establish the connection from. If the keyword is entered
correctly, connection is established and the projector will project
the images shown on the computer display. Use this function to
prevent unintended or unauthorized access to the projector
during presentations, from other points on the wireless LAN.
This option should normally be "ON". To disable this option,
select "OFF".