Epson EasyMP EMP-735, Setup Manual, Page: 30 / 223

29
E
nglish
Tip :
The projector keyword changes each time the projector power is turned OFF and ON
again, and when the wireless LAN card is removed and reinstalled. When connecting to
a computer, check the projector keyword displayed in the Connection Stand-by screen
and enter that keyword. Connection is not possible using a previous keyword.
In this section we will address computer connection setup. Connection setup is
performed using the utility software provided with the wireless LAN card.
If these settings are already established, this step need not be performed.
1 Turn on the computer and start Windows.
2
Start up the wireless LAN card utility software.
Refer to the documentation for the wireless LAN card for instructions on how
to use the wireless LAN card utility software.
If Easy connect mode advanced settings on the projector indicate the "Ad hoc
mode settings" as "ESSID ad hoc", you must also select ESSID ad hoc
mode on the computer. Set to the same ESSID shown on the Connection Stand-
by screen on the projector.
If Easy connect mode advanced settings on the projector indicate the "Ad hoc
mode settings" as "Channel ad hoc", you must also select channel ad hoc
mode on the computer. Set to the same channel shown on the Connection
Stand-by screen on the projector.
Computer Connection Settings
The value is displayed here.