Epson EasyMP EMP-735, Setup Manual, Page: 25 / 223

24
Connecting Using Easy Connect Mode
Steps for Connecting Using Easy Connect Mode
Caution :
• Do not unplug the power cable when EasyMP is in use (screens are changing or the
access lamp on the wireless LAN card is lit green).
• Do not remove the wireless LAN card when the access lamp on the wireless LAN card
is lit green, or when connected to a network. Doing so may damage the wireless LAN
card.
First, set up the Easy connect mode connection settings on this projector.
Connection settings are found on the Access point mode advanced settings screen of
the Network Screen.
Modify these connection settings using the remote control provided.
This step does not need to be performed if these settings have already been
established.
1 Insert the wireless LAN card into the card slot on this projector.
See "Installation" for details. p.16
2 Press the [Power] button on the remote control to turn on the projector.
3 Repeatedly press the [Comp/EasyMP] button on the remote control until
"EasyMP" is displayed at the top right of the projection screen. EasyMP
will automatically start and display the following screen.
Connection Settings on the Projector