26
Connecting to a projector on a different sub-net
By default, this application only searches for projectors on the same
sub-net as the computer. Therefore, even if you perform a search for
projectors on the network, one on a different sub-net will not be found.
You can, however, identify and connect to a projector on a different
sub-net, as follows.
• Specify either an IP address or projector name and perform a
search.
The IP address can be input directly. Also, provided the name of the
connected server has been registered on the DNS server, you
perform a search simply by inputting that name.
• Performing a search based on a profile
Once you have performed a search for a projector on a different sub-
net by specifying either an IP address or a projector name, you can
save the search as a profile with an easy-to-remember name, and
then use that profile whenever you subsequently want to search for a
projector on a different sub-net.
q
If a search fails to find a projector, the most likely causes
are as follows. Proceed as appropriate, depending on the
cause of the failure.
For both Windows and the Macintosh
• The wireless LAN signal is either out of range or weak.
Check whether there is anything that could be interfering
with the signal.
For the Macintosh
• "AirPort: On" is not set, or an appropriate access point is
not selected.
Check whether AirPort is set to "On". Or, check whether
an appropriate access has been selected.
Summary of Contents for EasyMP EMP-1705
Page 1: ...1 Operation Guide ...
