20
Configuration Menu Functions
TW500_English
(If the aspect mode is set to "Wide", keystone correction cannot be set.)
This is used to correct keystone distortion in images. The same correction can be carried
out using the projector's control panel.
Setup Guide
Median value (0)
This should be set in accordance with the method used to set up the projector.
•
Front
: Select when the projector is set up in front of the screen.
•
Front/Ceiling : Select when the projector is set up in front of the screen and
suspended from a ceiling.
•
Rear
: Select when the projector is set up behind the screen.
•
Rear/Ceiling : Select when the projector is set up behind the screen and suspended
from a ceiling.
Front
The projector is equipped with a power-saving function that causes the power to turn off
automatically and the projector to switch to standby if no signal is input to the projector
for a continuous length of time. The length of time before the power-saving function
operates can be selected from four available settings. If "OFF" is selected, the power-
saving function will not operate.
If you press
while the projector is in standby mode, projection will start again.
30min.
This selects the port that is used to connect a computer when using the Cinema Color
Editor to adjust the picture quality of images from the computer.
If you change the setting, the new setting will take effect after the power has been
turned off and the cool-down period is complete.
USB
When set to "ON", you can turn the power for the projector on using the remote control
window in Cinema Color Editor via the network when the projector is in standby mode.
If you would then like to use Cinema Color Editor to adjust the picture quality, check
that the projector is projecting images.
If you change the setting, the new setting will take effect after the power has been
turned off and the cool-down period is complete.
OFF
This is used to make network settings when connecting the projector to a network in
order to use Cinema Color Editor and the SNMP function.
It can also be used for checking the Projector Name and MAC Address which are
used for identifying the projector on the network.
This turns the trigger function on and off to determine whether the projector's power on/
off status and problems with projector operation are sent to an external device.
If you change the setting, the new setting will take effect after the power has been
turned off and the cool-down period is complete.
OFF
This lets you turn the settings for the various lock functions on and off. When a lock
function is on, a
icon appears on the screen when a button is pressed.
•
Focus Lock:
Focus adjustment is disabled.
OFF
•
Zoom Lock :
Zoom adjustment is disabled.
OFF
•
Operation Button Lock :
If this is set to "ON", you can't operate the projector's
control panel buttons. If you change the setting, the new setting will
take effect after exiting the configuration menu.
OFF
Keystone
Projection
Default setting
Operation
Sleep Mode
COM Port
Network Monitoring
Network
Trigger Out
Lock Setting
TW500-E.book Page 20 Wednesday, October 29, 2003 8:52 PM
