55
Problem Solving
T
roub
leshooting
Indicator statuses in normal operation
During normal operation, the
indicator is off.
: Lit
: Flashing
Lamp replacement warning
It is time to replace the lamp. Replace the lamp with a new one as soon as possible.
p.70
If you continue to use the projector without replacing the lamp, the lamp may blowout.
Standby condition
If you press
L
, projection will start after a brief interval.
Warm-up in
progress
Warm-up time is approximately 50 seconds.
While the projector is warming up, you cannot press
M
on the remote
control or
A
on the projector’s control panel to switch the projector
to standby mode.
Projection in
progress
Normal operation is in progress.
The indicator is off when the illumination function is set to "Off".
Cool-down in
progress
(Approx. 16
seconds)
Remote control and control panel are disabled while cool-down is in
progress. Once cool-down is complete, the projector turns to stand-by
mode. If the main power switch at the rear of the projector is turned off
while cool-down is still in progress, wait until the lamp has cooled
down sufficiently (approximately 10 minutes is required), and then turn
the main power switch back on.
Preparing for
network
monitoring
(EH-R4000 only)
None of the buttons can be operated while this is flashing.
Orange
Summary of Contents for dreamio EH-R2000
Page 1: ......
