d.
Press
INSERT
to display a list of file servers. Select a file
server upon which you have supervisor privilege.
(Assigning a queue on a file server actually installs the
print server on that file server. You can install the Ethernet
Card on up to eight file servers.)
e.
Select one or more queues from the “Queue Name” list. Use
the F5 key for multiple selections. You can create a new
queue by pressing
INSERT
and entering a valid, unique
queue name.
Press ENTER
to select queue(s).
10. After configuration, the LPT1 port is installed.
11. When you finish configuring ports, press
ESC.
Select “Yes” to
install and reset the Ethernet Card, or select “No” to return to
the “Print Port Configuration” screen. To quit without
installing the Ethernet Card, press
ALT X.
Caution:
Once you select “Yes”, you
must
wait
for
the “Installation has
been completed” message to appear before turning off the printer.
Turning off the printer before completion could erase the
interface’s memory; this could make the interface board unusable.
After a successful setup, the Ethernet Card’s red light goes off, the
green light lights, and the printer prints a configuration report.
The Ethernet Card is now ready to service queues.
Installing as
a
Remote Printer
Perform the procedures in “Before Running EPSETUP” and
“Running EPSETUP” to install the Ethernet Card as a remote
printer.
Installing the Ethernet Card
1-7
