Epson B107011F - GT 10000, User Manual

Page: 22 / 133

16
Setting Up Your Scanner
5. When you see a screen indicating that
Windows is ready to install the best
driver for this device, click
Next
to
begin driver installation.
6. If your system stops installation and
requests files from your Windows
operating system CD-ROM, replace
your scanner software CD-ROM with
your Windows disk and click
OK
to
continue. You may be prompted to
re-insert the EPSON disk after the
Windows disk.
7. When you see a screen indicating that installation is complete, click
Finish.
The
Add New Hardware Wizard closes, and you return to the Windows desktop.
8. To verify that the SCSI board was detected, click
Start
,
Settings
,
Control
Panel
, then double-click the
System
icon. Click the
Device Manager
tab, if
necessary. You should see
SCSI controllers
in the list. Click the
+
to expand the
list. You should see
Adaptec AIC-78XX PCI SCSI
in the list. Click
OK
to close
the dialog box.
9. When you’re finished, restart your computer.
If you’re running Windows 98, continue with the instructions on page 19 to install
your scanner software. If you’re running Windows 95, continue with the instructions
on page 24.
Installing the SCSI Software for Windows NT 4.0
Depending on how your computer system was originally set up, the SCSI driver may
be installed automatically when you start your computer. If not, follow the steps
below. You may be asked to insert your Windows operating system CD-ROM during
software installation. Please have your Windows CD-ROM handy, in case it is
needed.
shallot.book Page 16 Thursday, January 27, 2000 9:59 PM