Epson B107011F - GT 10000, User Manual

Page: 101 / 133

Solving Problems
95
If paper jams in the paper eject position,
open the cover on the right and slowly pull
out the jammed paper as shown. (Be
careful not to pull too hard or the paper
may tear, making it more difficult to
remove.)
After removing the jammed paper, close
the ADF cover and reset the scanner by
turning it off and on again or pressing the
RESET
button.
Adjusting the Scanning Position of the ADF
If your document feeds into the ADF
too far or not far enough, adjust the
scanning position using the adjustment
dials. This problem may occur if the
stopper is not installed or not
positioned properly on the document
table, so first make sure the stopper is
installed as described in “Installing the
Optional ADF” on page 36. To access
the dials, slide open the dial cover on
the rear of the ADF.
The right dial controls where paper stops when it is
first loaded from the feeder. The left dial controls
where double-sided originals stop during scanning of
the second side.
If the upper portion of the scanned image is missing, turn the dial clockwise.
If the lower portion of the scanned image is missing, turn the dial counterclockwise.
The position changes in 1-mm (0.04-inch) increments.
RESET button
dial cover
0
1
2
3
4
5
6
7
-7
-6
-5
-4
-3
-2
-1
mm mm
0
1
2
3
4
5
6
7
-7
-6
-5
-4
-3
-2
-1
shallot.book Page 95 Thursday, January 27, 2000 9:59 PM