Printer Problems
Your printer manual describes methods to solve most of your
printer problems. However, if your printer does not work
correctly right after you install it, check to make sure the printer
has power and is properly connected to the computer. If you
need additional help, the printer manual gives detailed instruc-
tions on how to connect your printer.
If you have printing problems, check the printer manual for the
printer’s correct DIP switch settings. The DIP switches on a
printer help it communicate properly with the computer and
you may need to make an adjustment for your configuration.
Be sure your software is set up for your printer.
Option Card Problems
If you install an option card and get unexpected results, check
the following:
1.
2.
3.
4.
Is the option card installed correctly? Check the setup and
operation procedures in the option card instructions.
Did you set the necessary DIP switches or jumpers on the
option card? See your option card instructions for these
settings.
Did you set the necessary DIP switches on the main unit
(as required by your option card)? See “Setting the DIP
Switches” in Appendix A.
If you added an external device to your Apex, did you use
the proper cable to connect the peripheral to the port or
option card connector on the back panel?
Troubleshooting 5-7
Summary of Contents for Apex
