Safety Instructions
14
❏
Be careful not to scratch the surface of the drum. When you remove the photoconductor unit
from the printer, always place it on a clean, smooth surface. Avoid touching the drum, since oil
from your skin can permanently damage its surface and affect print quality.
❏
To get the best print quality, do not store the toner cartridge in an area subject to direct sunlight,
dust, salty air, or corrosive gases (such as ammonia). Avoid locations subject to extreme or
rapid changes in temperature or humidity.
❏
To get the best print quality, when you temporarily remove the toner cartridge, the developer
unit, and the photoconductor unit from the printer, do not expose them to room light any
longer than necessary.
❏
Be sure to keep consumable components out of the reach of children.
❏
Do not leave jammed paper inside the printer. This can cause the printer to overheat.
❏
Avoid sharing outlets with other appliances.
Important Safety Instructions
Read all of the following instructions before operating your printer:
When choosing a place and power source for the printer
❏
Place the printer near an electrical outlet where you can easily plug in and unplug the power
cord.
❏
Do not place the printer on an unstable surface.
❏
Do not put your printer where the cord will be stepped on.
❏
Slots and openings in the cabinet and the back or bottom are provided for ventilation. Do not
block or cover them. Do not put the printer on a bed, sofa, rug, or other similar surface or in a
built-in installation unless proper ventilation is provided.
❏
All interface connectors for this printer are Non-LPS (non-limited power source).
❏
Connect your printer to an electrical outlet that meets the power requirements of this printer.
Your printer’s power requirements are indicated on a label attached to the printer. If you are
not sure of the power supply specifications in your area, contact your local power company or
consult your dealer.
❏
If you are unable to insert the AC plug into the electrical outlet, contact an electrician.
❏
Use the type of power source indicated on the label. If you are not sure of the type of power
available, consult your dealer or local power company.
