Exiting SETUP
When you leave SETUP, you can save your settings or exit
SETUP without saving your settings. You can also return all
values to the factory defaults.
The easiest way to leave SETUP is the following:
1.
On
any SETUP screen, press
F10.
2.
Select
Yes
to save your settings or
No
to exit without
saving.
3.
Press
Enter.
At any time during a SETUP session you can go to the Main
Menu (by pressing
E
SC
)
and save your settings or load another
set of values. The following table lists the available options.
Exiting SETUP options
Option
Description
Load ROM
Loads the factory default settings stored in ROM back into
Default Values
CMOS; if you change your configuration using SETUP and
then have problems, you can load ROM values to boot
the system and start over
Load Values
from CMOS
Loads the current values stored in CMOS for all SETUP
options; ignores any changes you have made through
SETUP
Save Values
Saves the changes you have made to your configuration
to CMOS
to CMOS
B-18
Running SETUP and Installing Drivers