Running SETUP
You may want to run the SETUP program the first time you use
your computer to customize the settings. You also may need to
run SETUP again later if you add options or change your
configuration.
Starting the SETUP Program
When you start your computer, it performs some power-on
diagnostics. During these diagnostics, you may see the following
message:
Press <DEL> to enter SETUP
Press Del. This message is on the screen for only a few seconds. If
you missed it, restart your computer and try again.
If, during power-on diagnostics, the system detects an error in
your system configuration, you hear two beeps and see an error
message followed by this message:
Press <F1> to resume, <DEL> to run SETUP
Press Del to run SETUP and correct the problem.
SETUP displays the Main Menu, which allows you to select
various options to identify your system’s configuration and then
save your new values. You can also cancel any changes you have
made and restore the default values stored in ROM or load the
previously stored values.
B-2 Running SETUP and Installing Drivers
