You see
a
diskette drive error
when you
start your
computer.
Run the SETUP program and configure your system for the
correct type of diskette drive. Make sure the Diskette Controller
option in SETUP is enabled. See “Configuring integrated
peripherals” in Appendix B for more information.
The diskette drive is making loud
or unusual
noises.
Contact your Authorized EPSON Servicer or the EPSON
Connection. To prevent damage to diskettes, do not put a
diskette into the drive until you identify and resolve the
problem.
Hard Disk Drive Problems
A new/y installed hard disk drive is not working properly of ifs
performance is not what you expect.
Make sure you have installed the drive correctly and check all
cable connections. Also, check the jumper settings on your drive.
If this is your only hard disk drive, make sure it is connected to
the primary IDE interface on the system board. If you have a
CD-ROM drive, make sure it is connected to the secondary IDE
interface and is not connected to the same interface as any hard
disk drive.
If you are using MS-DOS and Windows 3.1, make sure the PCI
IDE driver is installed and loaded; see “Installing the PCI IDE
Drivers” in Appendix B. To take advantage of the driver, your
hard disk drive must be compatible with the ATA-2
specification; check your hard disk drive documentation for this
information.
6-10 Troubleshooting
