4. Position the connector on the cable so the red wire aligns
with pin 1 on the drive. Make sure the holes in the cable
connector fit over all the pins; then push in the connector.
5.
Locate one of the power supply cables that lead from the
power supply. (They have multi-colored wires and a plastic
connector on the end.) Align the notched comers of the
power supply connector and the drive’s power connector;
then
push in the connector, as shown above.
Note
Your system includes five power supply cables; three
with full-size
connectors
and two with smaller
connectors.
If you need more than these five connectors,
you can purchase Y-adapters for power supply cables at
most computer accessory stores. A Y-adapter allows you
to use one connector for two devices.
lnstalling and Removing Tower Drives
6-7
