Adjusting the Loading Position
The loading position is the point where the paper stops when you
load paper using the
LOAD/EJECT
button. This position is important
because it determines where the printing begins on the page. If the
printing is too high or too low on the page, change the loading
position using the micro-adjustment feature as described below.
CAUTION: Never use the platen knob to feed paper
after turning on the printer. (If you need to use the
adjust the loading position, always use the following
1.
Make sure that the printer is turned on and that paper (single
sheet or continuous) is ready for loading.
2.
Press the
LOAD/EJECT
button to feed paper to the loading
position. Then press and hold down the
ON LINE
button until
the beeper sounds once and the
ON LINE
light begins to blink.
3.
Press
the FORM FEED
button to feed the paper forward or the
LINE FEED
button to feed the paper backward. When you
have
set the desired loading position, you
can
begin printing; the
ON
LINE
light automatically stops blinking.
Note: You
can
use the
FORM FEED
and
LINE FEED
buttons to
adjust the loading position only while the
ON LINE
light is
blinking.
P a p e r H a n d l i n g 2 - 7
