5.
Replace the computer’s cover; see “Replacing the Cover.”
Then see “Post-installation Procedures” for instructions on
configuring your computer with your new option card.
Installing a Card in the Slim line Computer (2-slot Sick)
The option card connector board in the slimline computer has
two slots on one side and three slots on the other. Although the
illustration shows an ISA card, you can use the same
instructions to install a PCI card. Follow these steps to install an
option card on the two-slot side:
1. Remove the retaining screw securing the slot cover bracket.
Remove the bracket by lifting it straight up and out of the
small metal holder that secures it.
slot cover bracket
2.
Remove the slot cover for the slot you are going to use.
3.
Hold the card by the top corners and guide it into the slot.
Then push the card in firmly (but carefully); you should
f&l it fit into place. If it does not go in smoothly, do not
force it; pull the card out and try again.
Installing and Removing Options
4-19
Summary of Contents for ActionPC 8000
Page 5: ......