6.
To connect the drive ribbon cables to the drives in the rear
internal bracket, first locate pin 1 on each drive’s connector.
The number I or 2 may be printed on the drive’s connector
or circuit board to identify the side of the connector
containing pin 1.
7.
Hold the cable connector so the red wire aligns with pin 1 on
the drive. Make sure the holes in the connector fit over all
the pins; then push in the connector.
8.
Locate a power supply cable for each drive installed in the
rear internal bracket. These cables lead from the power
supply and have multi-colored wires with a plastic
connector on the end. Align the notched corners of the
power supply connector with the drive’s power connector;
then push in the connector.
Installing and Removing Tower Drives
6-19
