8.
Secure the processor chip by pressing the ZIF handle back to
the closed position.
9.
Check the settings ofjumpers J11 and J13 to be sure they are
correct for the type of microprocessor you installed. You
may also need to change the setting of jumper J17 to match
the microprocessor type and operating speed.
If you installed a microprocessor with a different voltage
(check the table on page 3-23) you need to change the
settings ofjumpers J31 and J33. See pages 3-6 and 3-7 for
information on all these jumper settings.
10. If you are upgrading to a DX/ 40, DX/ 50, DX2, DX4, SX2, or
Pentium OverDrive processor, you must install a heat sink
and/or a fan, depending on the brand of processor you
installed. See the table on page 3-23 for more information.
Follow the instructions included with the heat sink if you
need to install one. If the heat sink comes with a fan, install
it using the instructions that came with the heat sink and
fan kit.
11. If you removed any option cards, replace them now; see
page 3-15 to replace a full-length card or page 3-16 to
replace a half-length card.
12. Run SETUP as described in Chapter 1 to update your
computer’s configuration with the new microprocessor
Post-installation Procedures
After you install or remove options, you must run SETUP to
update the computer’s configuration. See Chapter 1 for
instructions. Additionally, you may need to add some
commands to your configuration files. See your operating
system manual and the manual that came with your optional
equipment.
3-26
Installing and Removing Options
