Epson ActionDesk 4000, User Manual

Page: 50 / 163

Stopping a Command or Program
You may sometimes need to stop a command or program while
it is running. If you have entered a DOS or application program
command
that you want
to stop, try one of the following:
Press Pause
Press Ctrl C
Press Ctrl Break.
If these methods do not work, you may need to reset the
computer as described below. Do not turn off the computer to
exit a program or stop a command unless you have to, because
the computer erases any data you did not save.
Resetting the Computer
Occasionally, you may want to clear the computer’s memory
without turning it off. You can do this by resetting the
computer.
For example, if an error occurs and the computer does not
respond to your keyboard
entries,
you can
reset
it to reload
your operating system and try again. However, resetting erases
any data in memory that you have not saved; so reset only if
necessary.
Caution
Do not reset the computer to exit a program. Some programs
classify and store new data when you exit them. If you reset
the computer without properly exiting a program, you may
lose data.
Using Your Computer 3-5