EPSON Stylus COLOR 900/900N
Chapter 4 Disassembly and Assembly
108
4.2.8.8 ASF Sensor Removal
1. Remove the ASF unit. (See
2. Remove the right hopper release cam.
Figure 4-33. Removing the Hopper Release Cam
3. Remove the E-clip located just to the inside of the left hopper
release cam, as shown below.
Figure 4-34. E-Clip Removal
4. Slide the shaft to the left as far as it goes.
5. Remove the detection wheel by releasing the tab that secures it to
the left end of the shaft, as shown below.
Figure 4-35. Detection Wheel Removal
C H E C K
P O I N T
During assembly, match the orientation of the
right hopper release cam with that of the left
one.
S h a f t ' s S i d e F a c e
L D R o l l e r S h a f t
R e l e a s e H o p p e r L e v e r ( R i g h t )
Hopper Release Cam (Right)
Roller Shaft
C H E C K
P O I N T
During assembly, make sure that the hole in the
detection wheel faces the same direction as the
hopper release cam.
E-Clip
ASF Roller Shaft
F i x i n g T a b
D e t e c t i o n W h e e l
L D R o l l e r S h a f t
Roller Shaft
Summary of Contents for 900N
