Epson 830p - PowerLite XGA LCD Projector, User Manual

Page: 75 / 148

Fine-Tuning the Projector
75
Customizing Projector Features
You can use the menu system to turn standby mode on or off, adjust
the network settings, change the language, and customize the way the
projector displays images.
Remote Monitoring Setup Options
These options let you set up the projector so it can be monitored and
controlled from a remote computer (see page 80).
■
Standby Mode
(in the Extended menu)
Select
Network ON
to enable the projector to be monitored over
a network when it’s in standby mode.
■ If you want to monitor the projector using a network
management utility, select
SNMP
in the Network menu and
enter at least one trap IP address.
Miscellaneous Setup Options
■
Projection
(in the Extended menu)
Select
Front
(to project from the front of a screen and right side
up),
Front/Ceiling
(when the projector is mounted upside-down
from the ceiling),
Rear
(to project from behind onto a
transparent screen), or
Rear/Ceiling
(to project from behind onto
a transparent screen when the projector is mounted upside-down
from the ceiling).
■
Language
(in the Extended menu)
Select from nine languages to be used for the projector menus.
Enabling Sleep Mode
In Sleep Mode, the projector automatically turns off the lamp when it
has not received any signals from connected sources for 30 minutes.
This conserves electricity, cools the projector, and extends the life of
the lamp. When you want to start projecting again, just press the
P
Power
button.
In the Extended menu, select
Operation
,
Sleep Mode
, and choose
ON
or
OFF
.
note
When Standby Mode is set
to
Network ON
, the
exhaust fan continues to
operate after the projector
has cooled down. This is
normal.