Epson 830p - PowerLite XGA LCD Projector, User Manual

Page: 111 / 148

Solving Problems
111
Solving EasyManagement Problems
You don’t see your projector in the EMP Monitor window.
■ Make sure that you’ve connected the projector to the network and
configured it correctly; see page 80. Also, make sure you’ve
registered the projector with EMP Monitor; see page 81.
■ Make sure that Standby Mode in the projector’s Extended menu
is set to
Network ON
.
■ If the computer you are using is running Windows XP or 2000,
you must be logged in as the Administrator.
■ Try restarting your computer.
Solving Problems with the Remote
Control
The projector doesn’t respond to remote control commands.
■ Be sure the
ON/OFF
switch is in the
ON
position, as shown on
page 19.
■ The remote control’s batteries may not be installed correctly or
may be low on power. To change the batteries, see page 33.
■ Make sure your remote control’s ID is set to 0 or to the
projector’s ID; see page 73.
■ Make sure you are within about 33 feet (10 meters) of the
projector and within range of the projector’s front or back sensor
(approximately 20° to the left or right and 40° above or below).
■ Dim the room lights and turn off any fluorescent lights. Make
sure the projector is not in direct sunlight. Strong lighting,
especially fluorescent lights, may affect the projector’s infrared
receivers. Also, turn off any nearby equipment that emits infrared
energy, such as a radiant room heater.