Epson 7850p - PowerLite XGA LCD Projector, User Manual

Page: 35 / 224

Using the Remote Control
35
Controlling the Picture and Sound
You can use the remote control to preview and select your picture
sources, temporarily turn off the picture and sound, freeze the action,
zoom in on the picture, display a picture-in-picture image, and adjust
the volume.
Switching Between Picture Sources
If your projector is connected to more than one computer and/or
video source, you can switch between the different sources:
■ On the projector’s control panel, there are two
Source
buttons:
Press the
Computer/DVI
button to switch between EasyMP and
equipment connected to the
Computer
and
DVI
ports. Or press
the
Video/BNC
button to switch between equipment connected
to the
Video
,
S-Video
, and
BNC
ports.
■ On the remote control, there are six
Source
buttons. Use them to
switch between equipment connected to the port identified on
each button, or to use EasyMP to project wirelessly or from a
memory card.
Note that the
Computer
and
BNC
ports can be set up to use different
input signals (for example, Analog RGB or RGB Video)—so if you
have equipment connected to one of these ports, it’s important to
make sure the correct signal is selected to match the equipment you’re
using. You can change the input signal settings using the projector’s
menu system; see page 137.
After you select a source, the screen goes dark for a moment before the
image appears.
note
You can use the projector’s
menus to fine-tune the
picture and sound quality as
described in Chapter 4.
Source buttons