Epson 7800 - Stylus Pro Color Inkjet Printer, Printer Manual

Page: 137 / 176

5-137
Maintaining and Transporting the Printer | 137
Follow these steps to use maintenance mode:
1. Make sure the printer is turned off.
2. Press and hold the Pause button, then press the
P
Power button and
hold it until the printer turns on and displays
MAINTENANCE.
3. Use the
d
and
u
buttons to select the settings described below. If you
need to back up to the previous menu level, press the
l
button.
•
To print a hex dump of data in the printer’s buffer, press the
Menu
button to display
PRINT
. Then press the button to print the
16-byte hex data in the left column and corresponding ASCII
characters in the right column. Press the
Pause button to print
the last page.
•
To change the language on the LCD display, press the
d
button to
highlight
LANGUAGE
, then press
Menu
. Press the
d
button until
you see the language you want, then press to select it. The printer
exits maintenance mode and returns to normal operation.
•
To enable remaining paper counter, press the
d
button to highlight
REMAINING PPR SETUP
, then press
Menu
. Press the
d
button to
select
ROLL
, then press .
•
To change the units of measurement, press the
d
button to
highlight
UNIT
, then press
Menu
. Press the
d
button to switch
from
METER
to
FEET/INCH
, then press to select it. Press the
l
button when done.
•
To change the default cutting pressure, press the
d
button to
highlight
CUT PRESSURE
, then press
Menu
to display
100%
.
Press the
d
button to decrease the pressure, or the
u
button to
increase it (in 1% increments). Press to select the setting you
want.
•
To run a super strong cleaning cycle, press the
d
button to
highlight
SS CLEANING
, then press
Menu
to display
EXEC
. Press
to start the cleaning cycle.
•
To enable roll paper feeding at power-on, press the
d
button to
display
PWR ON ROLL PPR FEED
, then press
Menu
. Press the
d
button to select the setting you want, then press to save it.
7800-9800Guide.book Page 137 Monday, April 10, 2006 11:59 AM