Epson 755c - PowerLite XGA LCD Projector, User Manual

Page: 162 / 198

162
Solving Problems
Solving Network Problems
You don’t see your projector in the EMP Monitor window.
■
Make sure that you’ve connected the projector to the network and
configured it correctly; see page 52. Also, make sure you’ve
registered the projector with EMP Monitor; see page 122.
■
Make sure that Standby Mode in the projector’s Extended menu
is set to
Network ON
.
■
If the computer you are using is running Windows XP or 2000,
you must be logged in as the Administrator.
■
Try restarting your computer.
You can’t connect to the projector using NS Connection.
■
Make sure you’ve installed the Epson 802.11g card correctly in
the projector; see page 50. If you have to reinstall the card, restart
NS Connection or the program will not be able to detect the
projector.
■
Restart your computer.
■
Make sure your projector and computer are configured correctly;
see page 52 (Ad Hoc mode) or page 59 (Access Point mode).
■
Make sure that you have sufficient wireless signal strength (above
50 percent). On a Macintosh, check the AirPort icon on the
Macintosh menu bar. In Windows, see the documentation for
your computer’s wireless card or adapter for details.
■
Make sure you aren’t projecting one of the EasyMP configuration
screens. (You should see a message that the projector is ready to
connect.) If you have to exit a configuration screen, restart
NS Connection.
■
If the projector is configured for Access Point mode and you’re
using DHCP, allow time for your projector to appear. It takes the
server a little while to pick up the IP address.