Epson 6110i - PowerLite XGA LCD Projector, User Manual

Page: 97 / 130

Solving Problems
97
Viewing Lamp Usage and Other Information
Use the Info menu to view information about the image source, the
display settings of your computer, and the number of hours the lamp
and filter has been used.
Press the
Menu
button, select
Info
, then press
Enter
.
You see the lamp and air filter usage hours and various input signal
settings on the right:
The lamp typically lasts about 4000 hours. If the number shown is
close to that, make sure you have a spare lamp handy. If you’ve
installed a new lamp, be sure to reset the lamp timer (see page 91).
Red
Flashing red
The lamp may be burned out. First make sure the lamp cover is securely
installed. If that’s not the problem, remove the lamp and replace it as
described on page 89. If this does not resolve the problem, contact
Epson as described on page 106.
The lamp may be cracked or installed incorrectly. Check the lamp; if it is
cracked, you must replace it (as described on page 89) before you can
use the projector again.
If checking the lamp installation and replacing the lamp does not solve
the problem, contact Epson as described on page 106.
Red
Flashing red
The projector is shut down automatically because of an internal problem.
Remove the power cord and contact Epson for help, as described on
page 106.
Light Status Description
note
The information displayed
depends on the input signal
currently selected.
Lamp usage
Filter usage