2-19
Using Paper and Other Media
|
2-19
4. Remove the roll paper and spindle from the printer.
5. To remove the paper from the spindle, lay it on a flat surface, then
loosen the removable paper stop by tapping it with your hand. Slide the
paper stop off the end of the spindle, then remove the paper.
Always store unused roll paper in its original package—including the bag,
end caps, and box.
Using Cut Sheet Paper
You can print on many types of cut sheet paper and other media. The
printer accepts sheets ranging from letter-size (8.5 × 11 inches) to 44 × 62.2
inches. You can leave your roll paper in the printer when you print on cut
sheets; just make sure it’s rolled up and fastened with the roll paper belt(s), as
described on page 2-18.
If you’re using stock more than 19 mil (0.5 mm) thick, see page 2-20 for
instructions. You will not be able to follow the procedure described in this
section.
Follow these steps to load cut sheets:
1. Make sure the printer is on and the roll paper cover is closed.
2. Press the
Paper Source
button until the
Sheet
light comes on.
3. Make sure the paper set lever is pushed all the way in, in the secured
position.
Caution
To avoid damaging the
spindle, do not tap the
end of it on the floor.
