Page 50
EPS Stromversorgung GmbH
Alter Postweg 101 • 86159 Augsburg
Germany
Fon: +49 821 / 570451-0
Fax: +49 821 / 570451-25
www.eps-germany.de
PSI 10000 4U Serie
3.4.3.2
Sub menu “Profiles”
See
“3.9 Loading and saving user profiles“ on page 67
.
3.4.3.3
Sub menu “Overview”
This menu page displays an overview of the set values (U, I, P or U, I, P, R), device alarm thresholds, event set
-
tings, adjustment limits,
as well as an alarm history which lists the number of device alarms that occurred since
the device has been powered.
3.4.3.4
Sub menu “About HW, SW...”
This menu page displays an overview of device relevant data such as serial number, article number etc.
3.4.3.5
Sub menu “Function Generator”
See
“3.10 The function generator“ on page 68.
3.4.3.6
Sub menu “Communication”
This sub menu offers settings for digital communication via the built-in interfaces USB and Ethernet and also for
the optional interface modules of IF-AB series.
There is furthermore an adjustable communication timeout for USB or RS232, to make it possible to successfully
transfer fragmented messages (data packets) using higher values. In group
Protocols
you can disable one of the
two supported communication protocols, ModBus and SCPI. This can help to avoid mixing both protocols and to
receive unreadable messages, for example when expecting an SCPI response and getting a ModBus response
instead.
The USB itself doesn’t require any settings. The device will have following default Ethernet port related settings
which are listed in group
Ethernet (internal)
:
IF Settings
Description
Ethernet (internal)
DHCP
The IF allows a DHCP server to allocate an IP address, a subnet mask and a gateway. If
no DHCP server is in the network then network parameters will be set as defined below.
IP address
Manually allocate an IP address.
Subnet mask
Manually allocate a subnet mask.
Gateway
Manually allocate a gateway address
, if required.
DNS address
Manually allocate addresses of a Domain Name Server (DNS), if
required.
Port
Select port in the range 0...65535.
Default port:
5025
Reserved ports: 502 (ModBus TCP), 537
Host name
User definable host name
Domain
User definable domain
S
ettings for the optional interface modules (IF-AB-xxx)
IF Settings
Description
CANopen
Baud Rate
CAN bus baud rate selection that is used by the CANopen interface.
Auto
= Automatic detection
LSS
= Baud rate and node address are assigned by the bus master
Fixed baud rates:
10 kbps
,
20 kbps
,
50 kbps
,
100 kbps
,
125 kbps
,
250 kbps
,
500 kbps
,
800 kbps
,
1Mbps
Node Address
Selection of the CANopen node address in the range
1
...
127
