© EPS Stromversorgung in 2022, this information is subject to change without notice
40
30000800_manual_psb_10000_4u_30kw_en_04
2.3.9
Installation of an interface module
The optionally obtainable interface modules can be retrofitted by the user and are exchangeable with each other. The set
-
tings for the currently installed module vary and need to be checked and, if necessary, corrected on initial installation and
after module exchange.
•
Common ESD protection procedures apply when inserting or exchanging a module.
•
The device must be switched off before insertion or removal of a module
•
Never insert any other hardware other than an interface module into the slot
•
If no module is in use it’s recommended that the slot cover is mounted in order to avoid internal dirtying
of the device and changes in the air flow (models with air-cooling)
Installation steps:
1.
2.
3.
Remove the slot cover. If needed,
use a screw driver.
Insert the interface module into the slot. The
shape ensures correct alignment.
When inserting take care that it’s held as close
as possible to a 90° angle to the rear wall of
the device. Use the green PCB which you can
recognize on the open slot as guide. At the end
is a socket for the module.
On the bottom side of the module are two plas-
tic nibs which must click into the green board
(PCB) so that the module is properly aligned on
the rear wall of the device.
The screws (Torx 8) are provided
for fixing the module and should be
fully screwed in. After installation,
the module is ready for use and can
be connected.
Removal follows the reverse proce-
dure. The screws can be used to as-
sist in pulling out the module.
