23
In normal operating procedure
, it’s recommended to stop the outboard as following
steps.
1.
Rotate/Pull the throttle to zero position.
2.
Wait until the outboard stops, then remove the kill switch from tiller/remote
control.
3. Press and hold (≥2secs) the "POWER" button to power off the system.
4.
Tilt the outboard out of water and uninstall it from boat according to your
requirement.
In abnormal situations
like a fall over emergency, it’s recommended to stop the out-
board motor by removing the kill switch from the tiller.
In malfunction situations, the outboard will stop immediately for protection. The out-
board will stop if one of the following situations occurs.
1.
The throttle is in zero position.
2.
The power button is switched off.
3.
The kill switch is removed.
4.
The connection between tiller and battery is cut.
5.
The battery is empty.
6.
The outboard goes malfunctions (e.g. motor is blocked or the battery voltage
drops below 33V).
7.
Press the button of the safety wristband.
8.
The safety wristband is disconnected.
It’s recommended to tilt up the outboard out of water when the motor is not run-
ning.
5.4 Power off the External Battery
Please follow the steps below to power off the external battery.
1.
Stop the outboard (refer to 5.3 Stopping).
2.
Turn off the power switch.
3.
Turn off the battery (if the battery has a switch), unplug the external battery cable.
