36
4.6 Stopping the Motor
Usually, it’s recommended to stop the motor as the following procedures.
1. Return the throttle to the neutral position, then the throttle will lock
automatically.
2. Wait until the motor stops, then detach the kill switch from the Side Mount
Control.
3. Press and hold the "
" button until the Side Mount Control is powered
off.
4. If using the NAVY outboard or Pod Drive 3.0, turn off the main power
switch. If the outboard is connected to a NAVY battery, please also press
the battery power button to power off.
5. If using outboard, tilt the outboard above water surface or detach it from
boat.
The motor will stop if one of the situations occurs.
1) The throttle is in the neutral position.
2) The kill switch is not in the kill switch placement of Side Mount
Control.
3) The main power switch is off, while using a NAVY outboard or Pod
Drive 3.0.
4) The communication between Side Mount Control and the motor
breaks.
5) The connection between battery and the motor breaks.
6) Failure exists in the control system (e.g. motor is blocked or the low
battery voltage level is detected).
In case of emergency, the motor can be stopped by following operations:
1) Detach the kill switch.
2) Turn the throttle back to the neutral position.
Summary of Contents for Side Mount Control
Page 2: ......
Page 20: ...18 Figure 2 12 Starboard right Side Figure 2 13 Port left Side Throttle Throttle ...
Page 47: ......