EPICKA DY-1166, User Manual

Page: 3 / 6

Thank you for choosing EPICKA Travel Handheld Garment Steamer. The
following features are included with your Travel Fabric Steamer. Carefully inspect
the packing material for all parts listed below. To obtain possible missing parts,
refer to Page 10 of this manual for Consumer Service contact information.
Steamer Body
Steam Power Button
Steam Nozzle
Water Tank Cover
Power Indicator Light (2)
Water Tank (Boiler)
Power Cord
Product Information Operating Instructions
Steaming garments
Accessories
Anti-Scalding Gloves Storage Bag Measuring Cup
1. Remove all protective packaging material from the Steamer prior to its first use.
2. Place the Steamer on a flat surface, open the water tank cover, then use the
measuring cup to fill purified or distilled water carefully as shown below. Close
the cover after filling up, and make sure it seals properly. (NOTE: Please do
NOT fill the water tank directly from faucet, always use the measuring cup.
The capacity of the water tank is 2.7 fl oz or 80 ml, marked with MAX line on
the measuring cup.)
3. Plug the power cord into an electrical socket. The two power indicator lights
inside the water tank will slowly flash for 30 sec during pre-heating. After the
lights turn stable, simply press the button to turn the Steamer on. It is
recommended to steam to an open space for about 10-15 sec to stabilize the
flow before steaming your garment. Do NOT point the nozzle t to anyone, any
animal or any plant at any time when the Steamer is on. Please use in a
vertical manner with nozzle on the top side all time, with no more than 45
degree leaning to the ground. Do not use it with nozzle on the lower side at
any time.
4. Press the steam button again to turn off the steam flow when finished or not
using.
5. When the water level falls under MIN (in vertical position) and you still need to
continue with your steaming session, please turn off the Steamer and repeat
steps 2 to 4.
6. After use, always unplug the Steamer from the power socket and empty the
water tank.
Hang garment from a clean, rust-free hanger.
Direct Steam Nozzle towards bottom of garment. Steam will rise along inside
and outside of material, removing wrinkles. Slowly slide Steam Nozzle upward
from bottom to top of garment.
Direct Steam Nozzle away from garment and smooth material with your free
hand. Made sure to use anti-scalding glove provided in the package to avoid
potentially burning/hurting your hand
.
Repeat as necessary until garment is fresh and wrinkle-free.
3 4